升降平台不能行走的故障解决方法。Solution to the failure of the lifting platform in Shijiazhuang.

1.先对升降平台配件的升降平台电池进行检查看看有没有电压，如果电压有的检查电压是不是能够正常的使用。排除方法：电池没有电压或者是电压太低的话直接对其电池进行充电。Lifting platform for the first part of the lifting platform to check the battery to see if there is no voltage, if the voltage is not checked for some of the normal use of Shijiazhuang. Method: the battery does not have the voltage or the voltage is too low, then directly charge the battery.

2.检查铝合金升降平台配件升开关和线路有没有松动或者是短路的现象，微动开关有没有损坏。排除方法：维修和清理线路，更换或者是维修微动开关。Check the lifting parts of aluminum alloy lifting devices and circuits are loose or short circuit phenomenon, micro switch is not damaged. Methods: repair and clean the line, replace or repair the microswitch.

3.检查升降平台起升的接触器总成有没有烧坏或者是线圈短路和断路，排除方法：维修接触器的白金触点或者是直接更换一个新的液压接触器总成。Shijiazhuang check the lifting platform lifting contactor assembly has not burnt coil or short circuit and open circuit, troubleshooting: maintenance of contactor platinum contact or direct replacement of a new hydraulic contactor assembly.

4.检查起升的模块有没有烧坏或者是烧短路和断路的现象，排除方法：维修或者是更换模块总成。Check the lifting modules are not burnt or burnt short circuit and open circuit phenomenon, troubleshooting: repair or replace module assembly.

5.检查升降平台电机有没有电压到，检查电机有没有短路或者是断路和漏电的现象，检查碳刷有没有严重的磨损等。排除方法：维修线路，更换电机的碳刷和维修电机的铜头，维修电机总成或者是更换新的电机。Check Shijiazhuang lifting platform have motor voltage to the motor, check that there is no short circuit or open circuit and leakage phenomenon, there is no serious check brush wear. Troubleshooting: line maintenance, replacement and maintenance of motor brushless motor copper head, repair the motor assembly or replacement of the motor.

6.检查铝合金升降平台配件液压泵，多路阀，油管和油缸有没有损坏，排除方法：液压泵损坏维修或者是直接更换新的液压泵总成，多路阀损坏对其进行维修或者是直接更换新的多路阀总成，更换新的液压油管，油缸更换修理包或者是更换新的油缸总成。Check the Aluminum Alloy lifting platform hydraulic pump fittings, valve, pipe and cylinder are not damaged, troubleshooting: hydraulic pump damage repair or directly replace the new hydraulic pump assembly, maintenance or the direct replacement valve new assembly multiway valve is damaged, replace the new hydraulic oil cylinder replacement, repair the package or replacement of the cylinder assembly.

以上就是关于石家庄升降平台不能行走的故障解决方法的介绍，升降平台还可能出现其他的故障问题，因此，最好的办法是在购买石家庄升降平台时，选择正规的厂商，一旦出问题能够立刻修缮，这样才是最好的办法。The above is about the Shijiazhuang fault lifting platform can not walk solving method is introduced, the lifting platform may also occur in other fault problems, therefore, the best way is to buy Shijiazhuang lifting platform, choose the regular manufacturers, once the problem can be immediately repaired, this is the best way.